Kaz Vicks Personal Steam Inhaler

More Information

• Using Your Personal Steam Inhaler:
  - Fully unravel cord. Failure to do so could cause overheating and possible fire hazard. Do not use with extension cords. Place inhaler on a flat, stable surface for use.
  - Remove Inhaler Hood.
  - Turn the Vent Assembly counterclockwise until the Index Line is aligned with the Arrow on the top of the Base (just above the Switch). Note how the Tabs align with the slots in the Base. Lift the Vent Assembly straight up to remove it. - Using tap water, fill the Water Reservoir to just below the cup rim. Do not overfill. Use with water only. Do not add any medication or inhalant liquids, such as Vicks VapoSteam or Kaz Inhalant, to the water reservoir. An unsafe condition may result if anything is added to the water.
  - Replace the Vent Assembly. Align the Index Line with the raised Arrow on the Base. Be sure the Tabs align with the slots on the top of the Base, then turn the Vent Assembly clockwise until it locks into place.
  - Replace Inhaler Hood.
  - Connect cord to electrical outlet. Do not use with extension cord. Press the On/Off Switch to the ON position. The Indicator Light will illuminate.
  - The Steam Inhaler will take approximately 3-5 minutes to begin making steam. Use caution, the water reservoir and water will become extremely hot.
  - Move the Flow Levers counterclockwise for minimum steam flow. Place your face in the hood as pictured on the cover page. Do not rest your face on the Inhaler Hood because the soft plastic may bend, allowing steam to escape or causing the Inhaler to tip over and spill boiling water. Breathe normally through your nose and mouth, inhaling steam into your nasal and throat passages. Continue treatment for five to fifteen minutes.
  - When vapor therapy treatment is completed, move On/Off switch to the OFF position. The lamp will go out. Disconnect plug from electrical outlet. Allow the Steam Inhaler to cool before moving or refilling it (see Care and Cleaning section). Do not operate Steam Inhaler when empty.
• Care and Cleaning:
  Caution: Always disconnect the plug from the electrical outlet and let the Steam Inhaler cool down for at least 20 minutes before cleaning.
  - After Each Use
  1. Remove Inhaler Hood and Vent Assembly and wipe dry with a clean cloth or paper towel.
  2. If any water is left in the Water Reservoir, pour water out and wipe Reservoir and Base with a dry, clean cloth or paper towel. Never immerse the Base in water or other liquid.
  3. Replace Vent Assembly and Inhaler Hood; store in a cool dry place.

Warranty

1 Year limited warranty

Customer Reviews